| |
DESCRIPTION |
PARTS |
LABOR |
| 1. |
Haul
Block and Launch |
|
420.00 |
| |
Preserve
engines, 5 hours |
|
450.00 |
| |
Oil
and miscellaneous material |
1000.00 |
|
| |
|
|
|
| 2. |
Repair
the damage to the engines due to the water intrusion. Determine
the scope of damage internally, repair all internal damage.
|
|
|
| |
Remove
engines, 4 hours |
|
360.00 |
| |
Remove
engines' peripheral components, 4 hours |
|
360.00 |
| |
Ship
engines to machine shop for rebuild |
|
180.00 |
| |
Machine
shop charge plus mark up, new bearings, rings, gaskets |
1000.00 |
2000.00 |
| |
Replace
damaged electrical components |
|
|
| |
Labor
10 hours |
|
900.00 |
| |
Distributor
2 @ 380.88 |
761.76 |
|
| |
Ignition
coil 2 @ 92.29 |
184.58 |
|
| |
Ignition
cable kit 2 @ 65.32 |
130.64 |
|
| |
Alternator
2 @ 274.77 |
549.54 |
|
| |
Starter
2 @ 430.47 |
860.94 |
|
| |
Wiring
harness 2 @ 1070.00 |
2140.00 |
|
| |
Knock
sensor 2 @ 86.54 |
173.08 |
|
| |
Sender
2 @ 55.64 |
111.28 |
|
| |
Sensor
2 @ 101.59 |
203.18 |
|
| |
ECU
2 @ 1129.00 |
2258.00 |
|
| |
Cable
harness 2 @ 49.00 |
98.00 |
|
| |
Cable
harness 2 @ 490.00 |
980.00 |
|
| |
Strip
clamp, and misc. |
15.00 |
|
| |
|
|
|
| 3. |
Reinstall
and connect engines after repair to other items is complete,
16 hours |
|
1440.00 |
| |
Miscelleanous
materials, oil, filters, etc. |
300.00 |
|
| |
|
|
|
| 4. |
Seatrial,
test run and trouble shoot, labor 4 hours |
|
360.00 |
| |
Miscellaneous
materials, fuel, etc. |
100.00 |
|
| |
|
|
|
| 5. |
Replace
the U-joint and gimbal bearings. |
|
|
| |
R
& R outdrives, replace bearings, labor 5 hours |
|
450.00 |
| |
2
U-joints @ 59.99 ea. |
119.98 |
|
| |
2
gimbal bearings @ 64.38 ea. |
128.76 |
|
| |
|
|
|
| 6. |
Replace
the control cables, labor 4 hours |
|
360.00 |
| |
4
control cables @ $59.99 |
239.96 |
|
| |
|
|
|
| 7. |
Replace
the steering cable, labor 3.5 hours |
|
315.00 |
| |
Teleflex
ssc6126 steering cable |
275.00 |
|
| |
|
|
|
| 8. |
Replace
the three West Marine 665MCA batteries and battery cables,
labor 3 hours |
|
270.00 |
| |
3
batteries |
352.98 |
|
| |
battery
cables and connections |
142.40 |
|
| |
|
|
|
| 9. |
Replace
the engine room insulation, 2 hours |
|
180.00 |
| |
350
square feet of insulation |
350.00 |
|
| |
|
|
|
| 10. |
Replace
the Bennet trim tab motor and wires, 3 hours |
|
270.00 |
| |
motor,
wires and miscelleanous |
385.00 |
|
| |
|
|
|
| 11. |
Replace
the Fyre Watch FW200 FE241 fixed fire extinguisher, 3 hours |
|
270.00 |
| |
MA2-200
FE 241 unit |
399.99 |
|
| |
|
|
|
| 12. |
Clean
the fuel tank, replace any sending units and wires on the
tank, 4.5 hours |
|
405.00 |
| |
sender,
wires and miscellaneous |
92.00 |
|
| |
|
|
|
| 13. |
Replace
the Atwood Sahara S1100 bilge pump and wires below the engine,
2 hours |
|
180.00 |
| |
bilge
pump and wires |
95.00 |
|
| |
|
|
|
| 14. |
Replace
the electric engine hatch lift and associated wires, 3 hours |
|
270.00 |
| |
Danaher
or similar actuator and parts |
450.00 |
|
| |
|
|
|
| 15. |
Replace
the Promariner Flyback 10-3 battery charger and related wires,
3 hours |
|
270.00 |
| |
comparable
charger |
349.00 |
|
| |
|
|
|
| 16. |
Replace
the drive trim motors and related wires, 4 hours |
|
360.00 |
| |
Drive
trim motor and miscellenaous 2 @ $875 |
1750.00 |
|
| |
|
|
|
| 17. |
Replace
the two Atwood engine room blowers and related wires, 2 hours |
|
180.00 |
| |
2
blowers and miscellaneous parts 2 @ $40 |
100.00 |
|
| |
|
|
|
| 18. |
Replace
the Norcold DE451 refrigerator in the cockpit and its power
supply wires, 4 hours |
|
360.00 |
| |
Refrigerator
|
890.00 |
|
| |
|
|
|
| 19. |
Replace
the cockpit speakers, 1 hour |
|
90.00 |
| |
Speakers
and wires |
190.00 |
|
| |
|
|
|
| 20. |
Replace
the AC duplex outlet in the cockpit, 2 hours |
|
180.00 |
| |
Outlet
and wires |
45.00 |
|
| |
|
|
|
| 21. |
Replace
the cockpit courtesy lights, 2 hours |
|
180.00 |
| |
Lights
and wires |
120.00 |
|
| |
|
|
|
| 22. |
Replace
the Rule 500 bilge pump below the steps into the cabin, 1
hour |
|
90.00 |
| |
Bilge
pump and wires |
60.00 |
|
| |
|
|
|
| 23. |
Clean
the cockpit and inteiror carpet and any components, which
were submerged (including metal components to prevent corrosion).
- subcontract work |
|
700.00 |
| |
|
|
|
| 24. |
Ventilate
the vessel while under repair to prevent any mould or mildew |
|
NC |
| |
|
|
|
| 25. |
Replace
the Vacu-flush motor assembly and related wires, 3.5 hours |
|
315.00 |
| |
motor
assembly and wires |
600.00 |
|
| |
|
|
|
| 26. |
Clean
submerged portions of vessel thoroughly (yard prefers steam
cleaning) |
|
900.00 |
| |
assure
all salt water damaged components are addressed |
|
|
| |
|
|
|
| |
This
damage appraisal is prepared to assist in the estimation of
the repairs due to the damage to this vessel. It is not to
be construed as authorization to work, as this
authorization must come from the owner. Please amend the damage
appraisal as your professional experience dictates. |
|
|
| |
|
|
|
| |
Labor |
|
13,065.00 |
| |
Materials |
17,101.07 |
|
| |
Tax |
1325.33 |
|
| |
|
|
|
| |
TOTAL |
|
31,491.40 |
| |
|
|
|
